Sachs Speedforce 50 - Page 40

40
1
1
1
1
1
1
5
3
4
2
NOTES ON MAINTENANCE
Changing the bulb
NOTE
Use only tested, incandescent bulbs with
the ‘E’ designation. Use of non-approved
bulbs will void the operating license. Do
not touch the bulbs with bare fi ngers. Hold
bulbs with a clean, dry cloth when installing
or re mov ing them.
Low beam - high beam
bulb: 12V 15W
Position light
bulb: 12V/5W
- Turn off the ignition.
-
Remove the covering screws (1).
- Remove the screw (3) and take off the
front cover (4).
Headlight and position light
- Disconnect the plugs (5).
-
Take off the headlight cover (2).