SaeboStim Pro
Table 3 (Continued)
(including peripherals such as antenna
cables and external antennas) should
be used no closer than 30 cm (12
inches) to any part of the device).
Where “P” is the maximum output
power rating of the transmitter
in watts according to transmitter
manufacturer and “d” is the
recommended separation distance
inmeters.Fieldstrengthsfromxed
RF transmitters, as determined by an
electromagnetic site survey (b), should
be less than the compliance level in
each frequency range (c).
Interference may occur in the vicinity
of equipment marked with the
following symbol:
Note1: At 80MHz and 800MHz, the higher frequency range applies.
Note2: These guidelines may not apply in all situations. Electromagnetic propagation is
aectedbyabsorptionandrefectionfromstructures,objectsandpeople.
13