English
8
34
DISPLAY Description
1.22.5.2. It enables categories in report EVA-DTS
PA7
1.22.6.
VA1..3 Sales
1.22.7.
BA1-CA15-Cash
1.22.8.
DA1..7-CashLess
1.22.9. Delete value = 0 data from EVA-DTS report
Quick Reading
1.22.10. Prolongation of response waiting time from EVA-DTS data players
Extended Time-outs
1.23.
Allows selecting which beverages will be enabled for multiple brewing and the number of brewings.
The upper line will remain the same for all following operations, while the lower line will display the number
of consecutive beverages.
It is possible to set a value between 2 and 8.
Multiple beverage
…
1.23.1.
Multiple beverage
000
1.23.2.
It allows to enable or disable the beverage keys.
By pressing a disabled key during operation, the message “NOT AVAILABLE” will be displayed.
Enable Multiple Bev.
1.23.3.
enables the free-of-charge dispensing of the multi beverage, even if the machine works upon
payment.
If the parameter is set on NO, machine settings apply to the multi beverage.
Free
1.24.
Enables selection of whether the entries of the programming menu should be shown fully or only
partially.
Complete menus
1.25.
It enables creating a group of 2 instant product containers.
The groups of containers can be used when a higher capacity of instant powder is required for a particular product (e.g.
when chocolate is largely used in a certain location, 2 chocolate powder containers can be dedicated accordingly).
The machine software will be responsible for alternatively starting the two powder motors, to guarantee equal product
consumption in the 2 containers.
To use the instant product groups proceed as follows:
enter the System Management through the Groups option
enable groups management
select the pair of containers you would like to group together
programme the beverage recipe by introducing one of the 2 instant products that have been grouped.
Grouping Powders
1.25.1. Enables the instant product containers groups
Enable
1.25.2. Choosing the powder motor pair to be grouped together
Grouping Powders
1.26.
It allows selecting the current model of the vending machine.
The possible options are:
Espresso, Cappuccino, Instant, TTT, Cappuccino TTT, TTT NO Preground
The vending machine model is specified on the label located in the inside of the right-hand side panel.
VM Model
1.27.
Management of default values for machine configurations.
The user can create and recall his own configuration.
Default Menu
To Next Page
Loading...
