Saeco IPERAUTOMATICA - Page 35

English
8
35
DISPLAY Description
1.27.1.
It allows reverting the programmable parameters to factory preset values.
This operation does not reset the product counter.
Factory default
1.27.2. Management of the configuration which has been created by the user
Custom Default
Restoring the configuration which has been saved by the user on the machine
Read Custom
Saving the user machine configuration
Write Custom
1.28.
System Info
This option allows accessing a page showing the overall machine configuration.
The display shows the following information:
FIRST ROW: Sw version (“x.yy.zz” format) / Program CRC (“abcd” format)
Example: “SW v1.02.12/087c”
SECOND ROW: Boot loader version (“xx” format) and name of the file searched for by the boot
loader on the USB key (“.s19” extension not displayed)
Example: “Boot 08SAE_DA5P”
THIRD ROW: Memory version (“xxx.yyy.” format) / Content CRC (“zzz” format)
Example: “Mem 123.456.789”
System Info
2. The entries of the PAYMENT SYSTEMS are:
PAYMENT SYSTEMS
…
2.1.
Enables selection of the protocol used by the vending machine to dialogue with the payment system
installed on it:
EXECUTIVE Protocol;
PRICE HOLDING/DISP Protocol;
BDV Protocol;
MBD Protocol;
NO PROTOCOL (no serial protocol);
Master/Slave executive (the vending machine operates as master for another vending machine);
PHD Master /Slave (the vending machine operates as master for another vending machine that
works with the PRICE HOLDING/DISP protocol);
MDB SLAVE (the vending machine operates as slave to another machine);
The “NO PROTOCOL” setting will be used when a payment system operating with one of the
protocols provided by the other settings “EXECUTIVE”, “PRICE HOLDING”, “BDV”, “MDB”
“MDB SLAVE” or “EXEC MASTER/SLAVE” is not installed on the VM.
Is necessary since the VM continuously checks for dialogue with the provided payment system.
If the VM detects no dialogue, it signals this fault on the display through the message “NO LINK”.
This signal cannot be considered an error condition.
Protocol
2.2.
Allows enabling of the parameters of the parallel coiner, the mechanical coiner, the cancelling
machine and the choice of values to be assigned to the single money channels.
Entry description:
Parallel Coiner
…
2.2.1.
By setting "Y", the parallel coiner, the mechanical coiner and the cancelling machine control are
enabled.
If set on "N", the parallel coiner (if any) connected to the vending machine will be excluded.
Enable
no
2.2.2-6
It allows you to set the value of the coins forwarded to the vending machine by the parallel coiner, the mechanical
coiner and the punching machine.
The following "PAIRING TABLE" indicates how channels and related payment systems are connected to each other.
Coin Values
…
2.3.
It enables the parameters of the parallel banknote validator and the choice of values to be assigned
to single banknote channels.
Entry description:
Banknote Validator
…