English
8
38
DISPLAY Description
3.3.
This is the order in which the products making up the beverage are brewed.
The possible choices are:
0 =does not dispense any product
1 = dispenses product 1
2 = dispenses product 2
3 = dispenses product 3
4 = dispenses product 4
5 = dispenses product 5
C = brews coffee using instantly ground coffee
F = brews “fresh brew” coffee using pre-ground coffee
P = brews espresso coffee using pre-ground coffee
B = brews “fresh brew” coffee using instantly ground coffee
W = dispenses hot water
S = dispenses steam in the Cappuccinatore
Consequently, the combination of “3C00” or “30C0” or “03C0” will always dispense product 3 and
coffee beans.
The settings of products making up the beverage will be requested according to the sequence.
Sequence 1
0C00
3.3.
It allows setting the quantity of water to be dispensed for the programmed coffee type (C, P, F, or
B). The quantity can be set from “1” to “999”.
H2O /
Coffee
1
38
3.3.
Defines the amount of hot water to be dispensed.
The quantity of dispensable coffee can be adjusted from “1” to “999”.
Just water
1
101
3.3.
It determines the instant powder delivery rate.
The value can be set between 10 and 100.
The lower the value the smaller the powder delivery rate.
% instant
product
#:
1
3:50
3.3.
It determines the water delivery rate.
The value can be set between 20 and 100.
The lower the value the smaller the water delivery rate.
Important
If the sequence includes several instant products, the sequence “INSTANT PRODUCT - WATER -
DELAY INSTANT PRODUCTS - % OF INSTANT PRODUCT” will be shown again.
Important
If the setting relative to the instant product (“INSTANT PRODUCT - WATER”) means that the
powder dispensing lasts longer than the water dispensing, the vending machine stops powder
dosing (to avoid insufficient rinsing of the mixer) and emits a beep.
Readjust the set parameters in order to have a correct dispensing procedure, i.e. the powder
dispensing should stop a few seconds before the water stops flowing out. This is intended to allow
correct mixer washing.
% pump
#:
1
3:50
3.3.
This defines the quantity of instant product to be brewed.
Example: “5.0” quantity indicates that the motor of the instant product 3 will be activated for 5 tenths of a second.
The quantity of instant product is adjustable from “0.1 to “500.0” in steps of 0,1.
Brewing of the instant product does not occur when the parameter is set at “000.0” (in this case water is brewed).
Instant
prod.
dose #:
1
3:005.0
3.3.
It defines the amount of water to be mixed with the instant powder.
Example: “3” indicates that water will be mixed with the instant product 3.
“022” indicates that 22 units of water will be brewed with the instant product.
The reference unit is preset by the manufacturer.
The amount of water can be adjusted from ‘“1” to “1500” in steps of 1.
Inst. prod.
water #:
1
3:022
3.3. Dose of water for final cup wash
H2O Extra #:
To Next Page
Loading...
