English
8
37
DISPLAY Description
2.4.11.
By setting “N”, the credit inserted can be returned even if no sale has been made.
This function may be useful, for example, for changing banknotes into coins.
By setting “Y”, the credit inserted can be returned as change only after the sale has been completed.
Default = YES.
Commit to vend
no
2.4.12-16
Enables selecting which coins will be accepted by the MDB bill reader.
If set on "Y", the specified bill will be accepted.
On the contrary, the “N” setting prevents the banknote reader from accepting a specific banknote.
Default = All enabled.
Bill Enabling
…
2.4.13.
By setting “Y”, an inserted banknote is stored in the escrow position by the banknote reader (if
supported); this function is supported by the banknote reader.
In this way, if the sale fails or the card system fails to charge, the banknote will be returned.
By setting “N”, any inserted banknote goes to the banknote reader’s stacker, so that the banknotes
cannot be returned.
Default = No.
Bill Escrow
no
2.4.14.
When the vending machine is in Master mode, this menu enables setting of the address of any slave connected vending
machine.
If the vending machine is in Slave mode, it enables setting of its address.
Possible addresses are 0x40, 0x48 and 0x50.
Default = 0x40.
MDB Slave Address
0x40
2.5.
It allows the user to set the maximum credit which can be accepted by the vending machine.
Once this limit has been reached, the payment systems are disabled so that no more credit can be
accepted.
Default = 20.00.
Max credit
255
2.6.
Enables the user to use any residual credit to purchase other beverages.
By setting “N” (no), the residual credit will be collected by the vending machine.
Multivend
no
2.7.
It establishes the maximum time (expressed in seconds) beyond which the vending machine collects
the displayed residual credit.
The time is adjustable at intervals of 10 seconds.
Setting “000” the function is disabled.
Overpay Time
180
2.8. Enables setting of the number of fixed zeros of the credit.
Fixed Zeroes
0
2.9. Enables setting of the position of the decimal point of the credit.
Decimal Digits
0
3.
PRODUCT SETUP
…
3.1-5
It allows selecting the instant product for which you wish to enable powder dispensing before water
dispensing. This brewing cycle will be carried out only when the quantity of powder to be brewed
does not exceed 34.
Product Before
…
3.2.
It allows to enable or disable the beverage keys.
By pressing a disabled key during operation, the message “NOT AVAILABLE” will be displayed.
The beverages are associated with the keypad buttons.
See the following "BUTTON TABLE PHEDRA".
Beverage
Enabling
1
yes
3.3.
The vending machine is able to dispense 14 beverages.
Each beverage can be prepared by using ground coffee and/or instant products.
Technicians can select the desired products for the recipe (max 4) and their order of use.
Each component is identified by a number or a digit.
Beverage
Preparation
1
…
To Next Page
Loading...
