MAGIC 6. FAULTS
Saeco International Group REV.5 SEPT.2004 Page 3/3
Part Fault Cause
Varying cup filling volume
Overpress
ure valve
More water in drip tray
Overpressure valve does not
seal / calcified
Defective pump Dry coffee in dregs drawer / water low
indicator (fault LED)
Thermal fuse defective
Pump
Water leakage at overpressure valve
threaded joint
Hairline crack in joint area
Turbine calcified / other
deposits
Turbine
Varying coffee quantity
Water low indicator flashes
Hall sensor defective
Float not watertight
Float jammed
Magnet in float too weak
Float
Water low indicator lights up
(water level over reserve)
Electronic system defective
To Next Page
Loading...
