Saeco Primea Ring - Rinse Menu; Water Hardness Menu Intenza Aroma System

21
1
1 2 3
3 4 5
2
1234
A
B
C
Intenza Aroma System
Machine water hardness setting
Check the water hardness level obtained from the test.
The measurement can be used to set the Intenza Aroma
System correctly (see page 7). Matching parameters are
described on the upper part.
Immerse the water hardness tester
(included in the accessories) for one
second in water.
The test can be used only for
one measurement.
“RINSE” MENU
machine settings machine settings
rinse cycle
Note: This rinse cycle is performed every time the machine is turned on after the warming phase.
> machine settings > rinse cycle.
To clean the internal tubes in order to guarantee that the beverages are dispensed only with fresh water.
This function has been enabled by the manufacturer on all new appliances.
Select by navigating the click
wheel with your fi nger.
It is possible to set:
- yes
- no
“WATER HARDNESS” MENU - INTENZA AROMA SYSTEM
> machine settings > water hardness.
With the “Water hardness” function you can adjust your machine and the Intenza water fi lter to the level of
hardness of the water you use, so that the machine will request descaling at the right moment.
The water hardness in the Intenza water fi lter is expressed on a scale from A to C.
The water hardness in the machine is expressed on a scale from 1 to 4.
machine settings machine settings
water hardness
- 3 +
water hardness
Set and store the water hardness
according to the value on the tester.
Press the
button to save.
1.
2.
1.
2.
1.
2.
1.
2.
1.
2.