Safeline MX2 - Unit Number Programming

12
SafeLine MX2 v.5.2.1 EN
Conguration
Unit numbers
To remotely program a parallel connected unit, the unit number has
to be pre-programmed.
If units are connected in series (daisy chain), unit numbers can be
remotely programmed.
Remotely program unit numbers in SafeLines connected in
series:
Start programming
00
Enter the password
*0000#
Unit number
*82*n#
Terminate programming
*00*#
Programming the unit number
Dial phone number.
First unit answers
Program unit as number 1
Hang up
Re-dial the phone number
Press the next unit
number repeatedly
until hearing 3 beeps
The next unit answers
Program unit as
number [1- 9]
Hang up
End programming?
Unit programming is done