Safeline MX2 - Parameter List

15
SafeLine MX2 v.5.2.1 EN
Parameter list
Programming data Code Data Comments
Enter programming mode 00
Enter password * - - - - # Default = 0000
Exit programming mode *00*#
Alarm codes Code Data Comments
P100 ID code *01* - - - - - - - - # P100 is always 8 digits
CPC ID code *02* - - - - - - # CPC 6-8 digits
Q23 ID code *03* - - - - - - - - - - - - # Q23 is always 12 digits
Telephone numbers Code Data Comments
1st Phone number *11* - - - - - - - - - # Phone number to alarm receiver 0-16 digits. If
calling through a switch board, delay time can
be set by adding asterisks between leading
number of the switchboard and telephone
number for the alarm receiver. Each asterisk is
equal to one second delay.
Example: *11*(0)**1234567#
2nd Phone number *12* - - - - - - - - - #
3rd Phone number *13* - - - - - - - - - #
4th Phone number *14* - - - - - - - - - #
Call type Code Data Comments
Call type 1st number *21* - # Change the call type for the telephone
numbers stored.
0 = P100
1 = VOICE (Default)
2 = Q23
3 = CPC
Change this only if your alarm operator is
using any of the mentioned protocols.
Call type 2nd number *22* - #
Call type 3rd number *23* - #
Call type 4th number *24* - #
Call type LMS number *30* - # LMS (Lift Monitoring System) call type
0 = P100
3 = CPC (Only battery alarm)
4 = Caller ID (Battery powered only)