Sagem F@st 1704 User Manual

5 - Information / Configuration
Page 5-94 SAGEM F@st™ 1704 Reference Manual - 253272861-A
Sagem Communications SAS document. Reproduction and disclosure prohibited
5.8.1.1 Wireless – Basic
Field Action/Meaning Default value
Enable Wireless
Check the box to activate the wireless network (Wi-Fi).
Note: The steady "Wi-Fi" LED on the front of the router
shows that the wireless network (Wi-Fi) is
activated.
Checked
Hide Access Point
Check the box to mask the broadcast of the SS ID and
prevent any Wi-Fi connection on your router.
Note: When this box is checked, the router's SSID is
absent from the Wi-Fi adaptor user's own list of
monitored sites (Access Point).
Not checked
Clients isolation
Check the box to select the desired state:
• Disabled: to not isolate the Access Point i.e.
authorise machines connected to the router to
communicate with each other.
• Enabled: to isolate the Access Point, i.e. prohibit
machines connected to the router to communicate
with each other.
Not checked
Disable WMM
Advertise
Enable Wireless
Multicast
Forwarding (WMF)
SSID
Enter your router's SSID.
Note: This is indicated on the label stuck to the box.
SAGEM
BSSID
This is the MAC address of the router's Wi-Fi interface
(Access Point). In the "Structure" mode, this address
identifies a cell (BSS in English Basic Service Set). This
cell is a set formed by the access point and the stations
located in its coverage area.
You cannot modify this setting.
[Non
modifiable]
Country
Select the country of your choice from the scroll down list.
FRANCE
Max Clients
Maximum number of wireless customers for your router.
16
Note
The router may or may not be secured, at the request of the customer. This
level of security is indicated on the label pasted to the box.
This choice will modify the Wireless configuration screen

Sagem F@st 1704 Specifications

General

Brand	Sagem
Model	F@st 1704
Category	Network Router
Language	English