Sagem F@st 1704 User Manual

Annex A - Troubleshooting
Page A-8 SAGEM F@st™ 1704 Reference Manual - 253272861-A
Sagem Communications SAS document. Reproduction and disclosure prohibited
A.6 Restarting your router
We recommend that you restart your router if you notice that the router does not operate
properly:
To restart your router, use one of the following methods:
• Press the Power button located on the rear panel of the router. Press it again to switch it
back on.
• Click on the Reboot action of the HTTP configuration tool.
During restarting, the status of the LEDs is the following:
The
LED will light up first, followed by the four Ethernet LEDs (1 to 4), then these last four
LEDs will be off. The
and Ethernet (which corresponds to the connected interface) LEDs
should be steady and the
LED blinks during the establishment of the ADSL link, then
steadies like the
LED. The LED should be steady and turn from "Red" to "Green" when a
PPP session has been created.
Note
The powering up process lasts around one minute.
A.7 Resetting factory configuration
If you lose your password or if, after having entered new parameters in your router, you cannot
access the Internet nor the HTTP configuration tool, you can restore the normal operation with
the “factory” parameters via the Restore Default procedure.
When the procedure is finished you will have to enter again your connection ID and connection
password delivered by your Internet Service Provider (see Internet Connection – section 5.6)
To reset the default settings and therefore restore the router to its factory configuration, use one
of the following methods:
Important
This operation deletes the entire personalised configuration of your
router: Password, Configuration, etc.
After a factory configuration reset, it is necessary to install your router again
using the installation CD-ROM, or to enter again the ADSL connection data
supplied by your Internet Service Provider (ISP) (see Internet Connection
section 5.6).
• Press and hold for about 10 seconds the Reset button located on the rear panel of the
router.
• In the HTTP configuration tool, select Management > Settings > Restore default.

Sagem F@st 1704 Specifications

General

Brand	Sagem
Model	F@st 1704
Category	Network Router
Language	English