Accessories 51
Setting the alarm
The alarm function is represented on the screen by the symbol .
Permanent flashing of this symbol indicates that an alarm time has been programmed but the date and time clock has not
been initialised.
To use your phone as an alarm clock:
- Using the numbers or the scrolling arrows, set the alarm time.
- Press the righthand key to go to the next item.
- Set the minutes.
- Tick the box and validate by pressing
OK
.
The ringer is stopped by pressing any key; the alarm remains programmed.
The alarm function remains active when the phone is switched off. It is not affected by silent mode.
Setting the timer
The same procedure is applied as for the alarm function, but in this case you start a time clock running against a defined
value. The phone must remain switched on.
252203635_myH10_en.book Page 51 Vendredi, 12. août 2005 1:32 13
To Next Page
Loading...
Need help?
General
