SAGEMCOM RM50 User Manual

39
Appendix
In case of non receiving on the Internet, refer to the table here under:
What has been done with success What could be the trouble ?
The IP Radio is booted normally.
BUT
NO SIGNAL BAR ON THE SCREEN.
The IP Radio does not obtain an IP
address.
1. No DHCP server enabled. Please
confirm the setting of your router.
2. Incorrect WiFi encryption key is
entered. Please double confirm the key
and re-enter.
3. The network interface has difficulty.
1. The network interface of the IP
Radio is good.
2. The connection between IP
Radio and router was OK.
3. The IP Radio already obtained
an IP address.
BUT
ONLY ONE BAR SHOWED.
1. Cannot access the Internet radio
server.
2. The DNS lookup for the IP address of
the radio station failed.
3. Cannot obtain access to the router or
Internet.
Connection between IP Radio and
Internet radio server is OK.
BUT
ONLY TWO BARS SHOWED
1. Cannot obtain access to the radio
station.
2. The radio station rejected the
connection request.
Connection between IP Radio and
radio station is OK.
BUT
ONLY THREE BARS SHOWED.
1. The streaming service of the radio
station is unavailable or too heavily
loaded.
2. The IP Radio does not support the
service type of the radio station.
The connection between IP Radio
and the radio station was OK.
BUT
ONLY FOUR BARS SHOWED.
There is some buffering difficulty on the
internet. The available bandwidth is not
good enough to obtain a stable stream
from the radio station.

SAGEMCOM RM50 Specifications

General

Brand	SAGEMCOM
Model	RM50
Category	Radio
Language	English