33
base fan
nozzle fan-1
nozzle fan-2
2. Control
2.1 Temperature
2.1.1 Nozzle
Manually set up the temperature for nozzle.
2.1.2 Bed
Manually set up the temperature for heated bed.
2.1.3 Fan Speed
Set up fan speed, which defines the speed at which the fans spin. A higher fan speed allows for better cooling
and reduces oozing, but can also increases the shrinkage of the material.
Notice: This option if only for base fan and the nozzle fan-1 that located on the right side of the nozzle.
The nozzle fan-2 that located in the front of the nozzle is always ON and its speed is unadjustable.
To Next Page
Loading...
