41
Part 4: Installation the Mach3
5. About Mach3 license:
The mach3 software we provide is a trial version. It can only run up to 500 lines of G code, and does not affect the
testing of machine functions. The license can be obtained through the mach3 official website:
https://www.machsupport.com/
6. Start the Mach3 software：
Click on the desktop icon “Mach3Mill”, a dialogue of “Motion Control Hardware PlugIn sensed!” will be show.
Please select the“BL-UsbMach-V3.2”, you can also select “Don't ask me this again”.
To Next Page