EasyManua.ls Logo

SainSmart Genmitsu - Step 2: Load Engraving G-Code

SainSmart Genmitsu
49 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
43
Part 5: Engraving process example
Step 1
Turn on the control card's power switch button, LED (24V.PWR) is on.
Reset the software and display “Usbmach connected”. The control card is successfully connected, as shown below:

Related product manuals