SAJ PDS23-2SR75 User Manual

PDS23 Series
- 38 -
Fault
code
Fault description
Possible causes
Remedy
E003
Over-current during
deceleration
Too-fast deceleration
Increase deceleration time
Too-heavy and large-inertia load
Add proper braking units
lower-rating controller
Replace with higher-rating
controller
E004
Over-current at
constant running
speed
Sudden change of load
Check the load
Too low input voltage
Check the input power
supply or wiring
Lower-rating controller
Replace with higher-rating
controller
E005
Over-voltage during
acceleration
Abnormal input voltage
Check input power
Restart the motor when
instantaneous trip-off occurs
Avoid prompt restart when
trip-off
E006
Over-voltage during
deceleration
Too-fast deceleration
Add proper braking units
Abnormal input voltage
Check input power supply or
wiring
E007
Over-voltage at
constant running
speed
Abnormal input voltage
Install proper input AC
reactor
E008
Hardware
over-voltage
Abnormal input voltage
Check input power supply or
wiring
Too-fast deceleration
Increase deceleration time
E009
Under voltage of
DC bus
Too-low input voltage
Check input power supply or
wiring
E010
Controller overload
Too fast acceleration
Increase acceleration time
Restart the motor when
instantaneous trip-off occurs
Avoid prompt restart when
trip-off

SAJ PDS23-2SR75 Specifications

General

Brand	SAJ
Model	PDS23-2SR75
Category	Controller
Language	English