Sako SKI780 - Chapter 6 Function Code Table; 6.1 Brief introduction of function code

Chapter 6 Function Code Table
6.1 Brief introduction of function code
If PP-00 1s set to a non-zero number, parameter protection Is enabled. You must enter
the correct user password to enter the menu. To cancel the password protection
function, enter with password and set FP-00 to 0.
Group P and Group A are standard function parameters. Group U ts the monitoring
function parameters.
The symbols in the function code table are described as follows:
“Ye” : The parameter can be modified when the AC drive ts in either stop or running
state;
“x” : The parameter cannot be modified when the AC drive is in the running state;
“@” : The parameter Is the actually measured value and cannot be modified;
“*” : The parameter is factory parameter and can be set only by the manufacturer.
Table 6-1 Standard Function Parameters
PO Standard Function Parameters
Function | Parameter
Code Name Setting Range Default | Property
Motor | 0: Sensorless flux vector control (SFVC) p0-01 | control : Sensorless flux vector contro 2 ¢
2: V/F contro
mode
Command 0; Operation panel control (LED off)
p0-02 | source 1: Terminal control (LED on) 0 te
2: Communication control (LED
selection
blinking)
13 \wwwsakohzcom