Sako SKI780 - Page 20

6.1 Brief introduction of function code
PO Standard Function Parameters
ee sia Setting Range Default | Property
0: Digital setting (preset frequency
P0-08, press UP/DOWN to modify,
non-retentive at power failure)
1: Digital setting (preset frequency
P0-08, press UP/DOWN to modify,
retentive at power failure)
Main frequency | 2: All
P0-03 | source X 3: Al2 local potentiometer 3 *
selection 4: Panel potentiometer external
keyboard potentiometer
5: HDI pulse setting (DI5)
6: Multi-command
T: Simple PLC
8: PID
9: Communication setting
punlary The same as PO-03 (Main
P0-04 | frequency source 0 *
ysalection frequency source X selection)
Selection of Y
po-o5 | fange of auxiliary | 0: Relative to maximum frequency 0
- w
frequency source | 1: Relative to main frequency X
in superposition
Selection of Y
po.o6 | fange of auxiliary | oo, i50% 100% | +
frequency source
in superposition
www sakohzcom/ 14