Sako SKI780 - Page 21

6.1 Brief introduction of function code
PO Standard Function Parameters
Function Parameter
Code tetas Setting Range Default | Property
Unit's digit (Frequency source
selection)
0: Main frequency source X
1:X and Y operation
(operation relationship determined by
ten's digit)
Frequency 2: Switchover between X and Y
3: Switchover between X and "X and Y
source "
P0-07 superposition operation 00 Ww
4: Switchover between Y and "X and Y
selection :
operation
Ten's digit (X and Y operation
relationship)
0: X+¥
1:X-Y
2: Maximum
3: Minimum
P0-08 i 0.00Hz ~~ maximum frequency (P0-10) |50.00Hz| x
requency
Rotation 0: Same direction
P0209 direction 1: Reverse direction 0 *
po-1o | Maximum | 5 ooHz~ 500.00Hz 50.00Hz|
frequency
0: Set by PO-12
1:All
Source of 2: Al2 local potentiometer
PO-11 | frequency 3: Al3 panel potentiometer external 0 *
upper limit — | keyboard potentiometer
4: HDI pulse setting
5: Communication setting
P0-12 Frequency Frequency lower limit (P0-14) to 50.00Hz st
upper limit | maximum frequency (P0-10)
15 \wwwsakohzcom