Sako SKI780 - Page 32

6.1 Brief introduction of function code
P4 Input Terminals
Function Parameter
Code Nana Setting Range Default | Property
Unit's digit (Setting for All less
than minimum input)
0: Minimum value
1: 0.0%
Seting onl less Ten's digit (Setting for Al2 less
P4-34 | than minimum 000 w
‘iplit than minimum input)
P 0, 1 (same as All)
Hundred's digit (Setting for Al3
less than minimum input)
0, 1 (same as All)
P4-35 | Dil delay time 0.0s ~ 3600.0s 0.0s *
P4-36 | DI2 delay time 0.0s ~ 3600.0s 0.0s *
P4-37 | DI3 delay time 0.0s ~ 3600.0s 0.0s *
0: High level valid
1: Low level valid
Unit's digit (DI1 valid mode)
Divalitmods Ten's digit (DI2 valid mode)
P4-38 selection 1 Hundred's digit (DI3 valid mode) | 00000 *
Thousand's digit (DI4 valid
mode)
Ten thousand's digit (DI5 valid
mode)
p4-39 All input voltage/ | 0: Voltage input 0 ge
current selection | 1: Current input
www sakohzcom/ 26