Sako SKI780 - Page 34

6.1 Brief introduction of function code
P5 Output Terminals
Function
Code
Parameter
Name
Setting Range Default | Property
P5-02
Relay
function
(T/A-T/C)
P5-04
DO1 output
function
selection
21: Reserved
22: Reserved
23: Zero-speed running 2 (having
output at stop)
24: Accumulative power-on time
reached
25: Frequency level detection FDT2
output
26: Frequency 1 reached output
27: Frequency 2 reached output
28: Current 1 reached output
29: Current 2 reached output
30: Timing reached output
31: All input limit exceeded
32: Load becoming 0
33: Reverse running
34: Zero current state
35: IGBT temperature reached
36: Current limit exceeded
37: Frequency lower limit
reached(having output at stop)
38: Alarm output
39: Motor overheat warning
40: Current running time reached
41: Fault output (There is no output
if it is the coast to stop fault and
undervoltage occurs.)
www sakohzcom/ 28