Sako SKI780 - Page 45

6.1 Brief introduction of function code
P9 Fault and Protection
Function Parameter '
Coie Nama Setting Range Default | Property
Motor overload protection 0: Disabled
P9-00 | selection 1: Enabled i ®
P9-01 | Motor overload protection gain | 0.20 ~ 10.00 1.00 e
P9-02 Motor overload warning 50% ~ 100% 80% e
coefficient
P9-03 | Overvoltage stall gain 0~ 100 0 e
P9-04 Overvoltage stall protective 650 ~ 780V 760V e
voltage
P9-05 | Overcurrent stall gain 0~ 100 20 @
P9-06 Overcurrent stall protective 100% 200% 150% e
current
Short-circuit to ground upon 0: Disabled
pa-OF power-on 1: Enabled I e
P9-08 | Brake unit action starting voltage] 700 ~ 800V 750V e
P9-09 | Fault auto reset times 0~ 20 0 e
P9-10 | DO action during fault auto reset | 0: Notact 1:Act 0 @
P9-11 | Time interval of fault auto reset | 0.1s ~ 100.0s 1.0s e
Unit's digit: Input
input chase | gece) phase loss protection
nput phase loss protection, ' :
P9-12 | contactor energizing Teas aigié Baiitantos 11 e
protection selection energizing protection
0: Disabled
1: Enabled
P9-13 Output phase loss protection 0: Disabled 1 e
selection 1: Enabled
39 \wwwsakohzcom