Sako SKI780 - Page 48

6.1 Brief introduction of function code
P9 Fault and Protection
Function Parameter ,
Code Nema Setting Range Default | Property
Bus voltage upon _
P9-39 | Fault - e
Input terminal _
Pom leas upon 1* fault e
Output terminal _
P9-41 | status upon 1° fault . e
AC drive status
P9-42 upon 1* fault ° e
Power-on time
P9-43 upon 1* fault ~ ° e
Running time upon _ -
P9-44 | aS fault ®
Unit's digit (Motor overload, 11)
0: Coast to stop
1: Stop according to the stop
mode
2: Continue to run
Ten's digit (Power input phase
loss, 12)
Fault protection Same as unit's digit
P9-47 P Hundred's digit (Power output | 00000 Ww
action selection 1
phase loss, 13)
Same as unit's digit
Thousand's digit (External
equipment fault, 15)
Same as unit's digit
Ten thousand's digit
(Communication fault, 16)
Same as unit's digit
www sakohz.com/ 42