Sako SKI780 - Page 49

6.1 Brief introduction of function code
P9 Fault and Protection
Function Parameter ;
ode Name Setting Range Default | Property
0: Current running
frequency
Frequency selection for | 1: Set frequency
P9-54 | continuingtorunupon | 2: Frequency upper limit 00000 Ww
fault 3: Frequency lower limit
4: Backup frequency upon
abnormality
0.0% ~ 100.0%
P9-55 Backup frequency upon | (100.0% corresponds to 100.0% st
abnormality maximum frequency PO-
10)
Acbenspleciagat t Bus vali e constant
P9-59 | instantaneous power : 8 0 *
failiire control
2: Decelerate to stop
Action pause judging
P9-60 | voltage at instantaneous | 80% ~ 100.0% 85.0% *
power failure
Voltage rally judging
P9-61 | time at instantaneous 0.5s 05s *
power failure
Action judging bus
P9-62 | voltage at instantaneous | 80% ~ 100.0% 80.0% *
power failure
Protection upon load 0: Disabled
Pana becoming 0 1: Enabled a x
p9-64 Detection level of load 0.0 ~ 100.0% 10.0% ut
becoming 0
P9-65 Detection time of load 0.0 ~ 60.0s 10s ge
becoming 0
43 \wwwsakohz com