Sako SKI780 - Page 54

6.1 Brief introduction of function code
PC Multi-Reference and Simple PLC Function
Buse Se Setting Range Default | Property
PC-00 | Reference 0 | -100.0% ~ 100.0% 0.0% *
PC-01 | Reference 1 | -100.0% ~ 100.0% 0.0% *
PC-02 | Reference 2 | -100.0% ~ 100.0% 0.0% *
PC-03 | Reference 3 | -100.0% ~ 100.0% 0.0% *
PC-04 | Reference 4 | -100.0% ~ 100.0% 0.0% *
PC-05 | Reference 5 | -100.0% ~ 100.0% 0.0% vr
PC-06 | Reference 6 | -100.0% ~ 100.0% 0.0% vr
PC-O7 | Reference 7 | -100.0% ~ 100.0% 0.0% *
PC-08 | Reference 8 | -100.0% ~ 100.0% 0.0% *
PC-09 | Reference9 | -100.0% ~ 100.0% 0.0% *
PC-10 | Reference 10} -100.0% ~ 100.0% 0.0% *
PC-11 | Reference 11} -100.0% ~ 100.0% 0.0% *
PC-12 | Reference 12} -100.0% ~ 100.0% 0.0% *
PC-13 | Reference 13} -100.0% ~ 100.0% 0.0% *
PC-14 | Reference 14] -100.0% ~ 100.0% 0.0% *
PC-15 | Reference 15} -100.0% ~ 100.0% 00% *
0: Stop after the AC drive runs one cycle
Simple PLC | 1: Keep final values after the AC drive
PC-16 | running runs one cycle 0 Ww
mode 2: Repeat after the AC drive runs one
cycle
www sakohzcom/ 48