Sako SKI780 - Page 64

6.1 Brief introduction of function code
UO Monitoring Parameters
puaeien satan ns Default | Property
U0-24 | Linear speed 1m/Min e@
U0-25 | Accumulative power-on time 1Min @
U0-26 | Accumulative running time 0.1Min e
U0-27 | HDI pulse input frequency 1Hz e
U0-28 | Communication setting value 0.01% e
U0-30 | Main frequency X 0.01Hz e
U0-31 | Auxiliary frequency Y 0.01Hz e
U0-32 | Viewing any register address value 1 e
U0-35 | Target torque (%) 0.1% @
U0-36 | Rotation postion 1 e@
U0-37 | Power factor angle 0.1° e
U0-39 | Target voltage upon V/F separation lV e
U0-40 | Output voltage upon V/F separation lV e
U0-41 | Di state visual display dL. e
U0-42 | DO state visual display 1 @
U0-43 | Dl function state visual display 1(function 01-40) ‘L e
U0-44 | Dl function state visual display 2(function 41-80) 1 e
U0-45 | Fault information 1 oO
U0-59 | Current set frequency(%) 0.01% e
U0-60 | Current running frequency(%) 0.01% e
U0-61 | AC drive running state 1 e
U0-62 | Current fault code 1 e
U0-65 | Torque upper limit 0.1% e
www sakohzcom/ 58