Sako V780 - Page 23

17
P0 Standard Function Parameters
Function
Code
Parameter
Name
Setting Range Default Property
P0-25
Acceleration/
Deceleration time
base frequency
0: Maximum frequency (P0-
10)
1: Set frequency
2: 100 Hz
0 ★
P0-26
Base frequency for UP/
DOWN modi󽗉cation
during running
0: Running frequency
1: Set frequency
0 ★
P0-27
Binding command
source to frequency
source
Unit's digit (Binding
operation panel command
to frequency source)
0: No binding
1: Frequency source by
digital setting
2: AI1
3: AI2
4: Panel potentiometer
external keyboard
potentiometer
5: HDI Pulse setting (DI5)
6: Multi-command
7: Simple PLC
8: PID
9: Communication setting
Ten's digit (Binding terminal
command to frequency
source)
Hundred's digit (Binding
communication command
to frequency source)
0000 ☆
6.1 Brief introduction of function code