5. TROUBLESHOOTING AND SERVICE
Page 30
1. The error code of an error is displayed in the Speed
display window.
2. Up to three errors can be viewed with the latest one
first. The occurrence order is displayed in the Program
display window like “1”, “2” and “3”. If the same error
occurs successively, it is only registered once. If
multiple errors occur during one run, only one error that
has the highest priority is registered.
3. The error code is displayed as “E-xx“, except for the
balance error which is displayed as “bAL”. For details,
see the following tables.
5.3 Troubleshooting Charts
The following Troubleshooting Charts list caution messages
and error codes that could occur during operation of the
Cyto-Tek
®
2500 Cytocentrifuge. Possible problems could be
electrical, operational, or mechanical. Probable causes and
recommended remedies are also included so that isolated
problems can be quickly corrected.
If additional assistance is required concerning an
instrument problem, an error code displays that is not listed
here, or if the problem cannot be isolated or is beyond the
scope of this manual, complete the “PreService Checklist”
at the end of this section. Then contact the Technical
Support Department of Sakura Finetek USA., Inc. by calling
toll free 1-800-725-8723, option 2 (U.S. only). If located
outside the United States, contact the nearest Sakura
instrument distributor or representative for information and
assistance.
To Next Page
Loading...
Need help?
General
