Page 5
1.3.3 Control Panel (Figure 1F)
START/STOP key
Starts and stops the operation.
SET key
Switches the Standby mode to the Program mode and the Set
& View mode.
(down-arrow) key
Changes a program number and decreases a setting value for
the rotation speed or process time.
(up-arrow) key
Changes a program number and increases a setting value for
the rotation speed or process time.
Program Number display (7-segment display)
Displays a program number from 1 to 30.
Speed display (7-segment display)
Displays a programmed rotation speed or an actual speed.
Time display (7-segment display)
Displays a programmed process time or a process time left.
Lid Lock indicator
An orange light is displayed when the instrument lid is locked
prior to the start of operation and goes out when the lid is
unlocked after the motor has stopped.
Power indicator
Lights up while the power is supplied to the instrument.
To Next Page
Loading...
Need help?
General
