Salente Cuco - Page 75

75
Electrical fuse is blown.
Contact customer service for
a replacement fuse.
18. Rice only partially
cooked or is too hard.
Didn't use enough water.
Adjust rice to water ratio
according to recipe.
Lid opened too early.
After cooking cycle is
complete, leave the lid on for
an extra 5 minutes.
19. Rice is mushy or
watery.
Used too much water.
Adjust rice to water ratio
according to recipe.
l
f any of the below error codes appear on the pressure cooker display, unplug the
power cord and check if the pressure cooker is properly assembled, if the food is
properly and evenly positioned, and if there is enough liquid in th cooker. Then, let it
cool for at least 1O minutes and plug it back into the outlet and turn it on.
lndicator code
Problems/Causes Contact the Customer support
EI
Open Circuit of the
Sensor
Contact the Customer support
E2
Short Circuit of the
Sensor
Contact the Customer support
E3 Overheating
Turn it OFF/ON and if still
indicating Error, contact the
Customer support
EY
Signal Switch
Malfunction
Contact the Customer support