To Next Page

To Previous Page

2. Montage

2.1 Package content

1) VS35W/VS35B thermostat

2) Short instruction

3) Mounting screws

2.2 Proper thermostat location

Please note:

The ideal position to thermostat mounting is about 1,5m under oor level far from heating or cooling sources. Thermostat can’t be

exposed to sunlight or any extreme conditions like for example draft.

Because of re and explosion risk there is not allowed to use thermostat in atmosphere of explosive gases and ammable liquids (eg coal dust). In case

if any of listed dangers occur you have to use additional protection measures – anti-dust and explosive gases (tight cover) or prevent their formation.

Furthermore, thermostat can’t be used in condensation of water vapor conditions and be exposed to water action.

2.3 Wall mounting

Mounting: to mount thermostat you can use accesories included with the set (mounting screws). Remove back cover to mount the plate to the wall.

After this just attach thermostat to the plate right into designed holes in the plate. The VS35 thermostat has been designed for ush mounting in a

standard electrical box with a diameter of 60 mm.

Open the housing with a

screwdriver - as shown in

the pictures above.

Mount the plate to the

wall using mounting

screws, in the correct

direction.