Sam4s ER-280 SERIES - RS-232 C Serial Cable Installation

3. Installation and Operation
3-4 SAM4S ER-280 SERIES
3-2 Installation
3-2-3 RS-232C Serial Cable Installation
1. Open the I/F Door.
2. Connect the RS-232C serial cable to the RS-232C serial port on the rear side of ECR.
3. Secure the serial cable with screws.
4. Connector the other end of the RS-232C serial Cable to your host computer.
Figure 3-4. Cable Installation
3-2-4 Options
No. Item Description Remark
1 Water Proof Raised Keyboard (Option)
2 Memory SRAM 4MBITs (4MBITs * 1) On Main PBA
3 Pulley Winding Spool motor & Pulley Factory option
Table 3-1. Option
3-2-5 Supplies
No. Item Description Remark
1 Paper Roll 1 EA
2 Mode Key
VD, REG, X, Z, P, C : NON FISCAL
REG, X, Z, P, C : FISCAL
3 User Manual 1 EA
4 Spool 1 EA
Table 3-2. Supplies