Sam4s ER-430M - Program 100 - PLU Status Programming

144 • Program Mode Programming Sam4S 230, 3xx, 4xx, 52xx Electronic Cash Register AU
Program 100 - PLU Status Programming
NOTE: PLUs default to Taxable by Rate 1 - Australian GST
Programming PLU/PLUs Status
1. Turn the control lock to the PGM-Mode.
Switch to P Mode by press MODE function key. (For ER-230)
2. To begin the program, enter 1 0 0, press the SUBTL key.
3. Select the PLU or PLUs you wish to program in one of the following ways:
• Press a PLU on the keyboard, or
• Press the first PLU in a range of PLUs that are to receive the same setting then press
the last PLU, or
• Enter up to 15 digit number of the PLU and press the PLU key, or
• Enter the number of the first PLU in a range of PLUs that are to receive the same
setting; press the PLU key. Enter the last PLU number in the range; press the PLU
key, or
• For a barcode item, scan the barcode. (Only for single item.)
4. Refer to the "PLU Status Chart" to determine the values for N1 through N9. (If an
address offers more than one option, add the values for each option and enter the sum.
For example, if you wish the PLU to be taxable by rates 1 and 3, add the values for your
choices, 1 + 4, and enter the sum "5" for address N5.) Enter the values you have selected,
press the X/TIME key. (You do not need to enter preceding zeros. For example, if you
are only selecting a value for N9, i.e. auto tare by number 1, just enter 1.)
5. To program additional PLUs, repeat from step 3, or press the CASH key to finalize the
program.
CASH
N3 N2 N1 N4 N5 N6 N7 N8 X/TIME N9
PLU
PLU
PLU
PLU
Enter the PLU#,
up to 15 digits
PLU
Enter the first PLU#,
up to 15 digits
Enter the last PLU#,
up to 15 digits
PLU
0 SUBTL0 1