Sam4s ER-5100? SERIES - 4 Disassembly and Assembly; 4-1 Disassembling the Case Upper Block

SAM4S ER-5100II SERIES 4-1
4 Disassembly and Assembly
Caution:
· Before installation, be sure to turn off the power switch.
· Use gloves to protect your hand from being cut by the angle and the chassis.
· Connect all the cables correctly. When connecting or disconnecting the cables, be careful not to apply
stress to the cables. (It may cause disconnection)
· Be careful not to bind interface cables and AC power cord together.
Note: Before disassembling, first of all separate the ASS'Y CASE UPPER(B) from the ASS'Y CASE LOWER(D).
4-1 Disassembling the Case Upper Block
4-1-1 Ass’y Case Upper
1. Open the ASS'Y COVER PRINTER(A ) and lift it off. (Page7-1,7-2)
2. Remove the four screws(B-6:3pcs,B-11:1pcs) from the ASS'Y CASE LOWER(E). (Page7-3,7-11)
3. Separate the two harnesses(ⓑ,ⓒ) from the MAIN BOARD(D-2). (Page7-11)
4. Lift off the ASS'Y CASE UPPER(B) from the ASS'Y CASE LOWER(E). (Page7-1,7-2)
4-1-2 Ass’y VFD Display
1. Separate the WINDOW DISPLAY(B-7) from the ASS'Y CASE UPPER (B). (Page7-1,7-3)
2. Separate the FRONT DISPLAY BOARD(B-14) from the ASS'Y CASE UPPER(B). (Page7-1,7-3)
3. Separate the two harnesses (ⓐ,ⓒ) from the FRONT DISPLAY BOARD(B-14). (Page7-3)
4-1-4 Ass’y Rear VFD Display
1. Separate the ASS'Y TURRET(B-10 ~ B-10) from the ASS'Y CASE UPPER (B). (Page7-1,7-3)
2. Separate the WINDOW TURRET(B-10) and the VFD DISPLAY BOARD(B-9) from the ASS'Y TURRET.
(Page7-1,7-3)
4-1-5 Ass’y Cover Mode Switch
1. Separate the ASS'Y COVER MODE S/W(B-1 ~ B-5) from ASS'Y CASE UPPER(B). (Page7-1,7-3)
2. Remove the two screws(B-5) on the ASS'Y COVER MODE S/W(B-1 ~ B-5) and separate the ASS'Y
SWITCH ROTARY(B-2 ~ B-4) from the COVER MODE S/W(B-1). (Page7-1,7-3)
3. Remove the two screws(B-2) on the ASS'Y SWITCH ROTARY(B-3 ~ B-4) and separate the BRKT MODE
SWITCH(B-3) and the SWITCH ROTARY (B-4). (Page7-1,7-3)