Sam4s ER-5100? SERIES - 5 Alignment and Adjustments; 5-1 Adjustment Procedure

SAM4S ER-5100II SERIES 5-1
5 Alignment and Adjustments
This chapter describes the methods for aligning and adjusting components in this ECR.
5-1 Adjustment Procedure
Figure 5-1. Adjustment Procedure
Slide the Reset signal adjustment plate on the Guide frame to the left or right as necessary so that skew(a) is
within the rated value.
Figure 5-2. Adjustment Point
Rated value : (a)≤ 1dot (0.4mm, normal temperature)
* To adjust the left side on JOURNAL SIDE.