10
TIPS FOR USING THE GUN
When mounting the head on the gun, hold the gun vertically to position the
head correctly before tightening the head ring.
Always position the gun perpendicular to the surface to be painted.
Do
not forget that cross passes do not make up for irregularities. Spraying
with the
gun stopped gives a local overload.
Make sure to obtain a good and regular overlapping of the different
passes (gun moving vertically, pieces to be painted moving
horizontally).
J
MACHINE RACE
(CM
This width J 2 for 2 regular coats of paint corresponds exactly to the following
formula :
J 2 (m) = VP (m/s) x 2
CM (m)
VM
(m/s)
PARTS
)
Formula in which
:
VP = feed speed of the products to be painted.
CM = total stroke of the machine (thus of the guns).
VM = speed of the machine (and therefore of the
2 = 2 regular
coats overlapping.
(4 if one wanted double the number of
To Next Page
Loading...
