How to fix a SAMES KREMLIN A28 Paint Sprayer when the paint stops spraying?
If the paint no longer comes out of your SAMES KREMLIN Paint Sprayer, it's likely due to a clogged nozzle. To resolve this, turn off the pressure on the pump, then remove and clean the nozzle thoroughly. Make sure to decompress the hoses well.
What to do if my SAMES KREMLIN Paint Sprayer is leaking paint?
If your SAMES KREMLIN Paint Sprayer is leaking, there are several potential causes. It could be due to impurities in the paint; try opening and closing the gun control 3 or 4 times to clear them. Alternatively, the needle might be worn out, in which case you should replace the needle and nozzle. Finally, a worn cartridge or gasket could be the culprit, requiring replacement.
Why does the head of my SAMES KREMLIN A28 get dirty so often?
Frequent dirtiness of the SAMES KREMLIN Paint Sprayer head can stem from a couple of issues. One possibility is that the air pressure is too high; try reducing it. Another cause might be a leak in the fluid seal or cartridge, which would necessitate replacing the seal or cartridge.
Why does the spray jet narrow at reversals with my SAMES KREMLIN Paint Sprayer?
If the spray jet narrows at reversals when using your SAMES KREMLIN Paint Sprayer, it could be caused by air intake in the paint. Ensure that there are no air intakes in the suction pipe. Another potential reason is that the paint viscosity is too high. If so, dilute the paint to achieve the correct consistency.
What causes paint to come out of the air holes in the head of my SAMES KREMLIN A28?
If paint is coming out of the air holes in the head of your SAMES KREMLIN Paint Sprayer, it could be due to a defective nozzle seal; if this is the case replace it. Another possibility is an insufficiently tightened ring; try squeezing it to tighten.
General safety guidelines for users, emphasizing professional use and adherence to recommendations.
Ensuring the equipment remains unmodified and used only for its intended purpose.
Highlights the A28 HPA's features and recommended applications with Superlife technology.
Lists relevant ATEX directives and standards applied to the equipment.
Explains ATEX marking codes and their meaning for equipment used in explosive atmospheres.
Details operational parameters like pressure, flow rate, temperature, materials, and connections.
Provides a diagram for connecting the spray gun, air, and fluid lines.
Instructions for temporary shutdowns, focusing on minimal cleaning if the head is lightly soiled.
Procedure for extended periods of non-use, including disassembly, cleaning, and storage preparation.
Guidelines for storing the equipment before assembly, including environmental conditions and handling.
Recommendations for storing the equipment after installation, emphasizing safety regarding flammable products.
Describes faults related to the bean-shaped spray pattern and their causes.
Identifies issues with an offset spray pattern and potential causes.
Explains problems with a cut spray jet, relating to air pressure and product flow.
Addresses issues with center-loaded spray patterns, often due to paint flow or viscosity.
Diagnoses causes of paint jet jerks, usually related to air in the paint circuit or improper setup.
Provides a benchmark reminder for disassembling the A28 pistol.
Step-by-step guide for disassembling the diaphragm assembly of the A28 gun.
General| Brand | SAMES KREMLIN |
|---|---|
| Model | A28 |
| Category | Paint Sprayer |
| Language | English |
To Next Page
