Samlexpower Evolution Series - Page 10

10 | SAMLEX AMERICA INC.
EVO INVERTER/CHARGER | Quick Start Guide
13. The rst parameter you should change is the Date and Time
Refer to Section 4.10 of the EVO-RC Owner's Manual).
T
o set time and date (no password required):
• Pr
ess Enter from any Operating Mode Screen.
• Screen
SELECT GROUP
CHARGE CURVE
SELECT GROUP
TIME SETTING
TIME SETTING
2000/01/01 00:00
Up Key x 5
ò
Enter Key
ò
will appear. Press Up Key 6 times.
•
Screen
SELECT GROUP
CHARGE CURVE
SELECT GROUP
TIME SETTING
TIME SETTING
2000/01/01 00:00
Up Key x 5
ò
Enter Key
ò
will appear. Date and time syntax is YYYY/MM/DD HR:MM
• Cursor will blink on value to be changed.
• Press Up/Down to change value.
• Press Enter momentarily to move to next value.
• When Date and time is corr
ect, press and hold Enter Key for a few seconds to write
your settings.
Y
ou are done setting the time and date.
This Quick Start Guide provides basic steps required for planning the installing and operating EVO
TM
Series Inverter Charger. Based on the specic application, actual installation procedure will vary.
Plan your installation accordingly. Please read the entire EVO
TM
Owner’s Manual. Samlex Customer
Service and Application Engineers are available to assist you with installation, setup, and operating
instructions.