Samson 3241 - Dimensions and Weights

3-6 EB 8015 EN
Design and principle of operation
Dimensions and weights
The weights specied apply to a specic standard device conguration. Weights of other
valve congurations may differ depending on the version (material, trim etc.).
Table 3-1 to Table 3-3 provide an overview of the dimensions and weights of the standard
version of Type3241 Valve. Table 3-4 and Table 3-5 list the dimensions and weights for the
Type3241 Valve with insulating section or bellows seal.
Dimensions in mm · Weights in kg
Table 3-1: Dimensions of Type3241 Valve, up to DN150
Valve DN 15 20 25 32 40 50 65 80 100 125 150
Length L mm 130 150 160 180 200 230 290 310 350 400 480
H1 for
actua-
tor
≤750cm² 222 223 262 354 363 390
1000cm²
1400-60cm²
– 413 423 450
1400-
120cm²
2800cm²
–
H2
1)
for
Cast steel 44
2)
72 72
2)
98 98
2)
118 144 175
Forged steel 53 – 70 – 94 100 – 132 –
1)
The H2 dimension is the distance from the middle of the ow path to the bottom of the valve body.
2)
The H2 dimension in this valve is not the lowest point of the valve. This valve's lowest point is the
bottom of the connecting anges. The ange dimensions comply with the corresponding ange stan-
dard.
Table 3-2: Dimensions of Type3241 Valve, DN200 and larger
Valve DN
200 (cast
iron) 200
250
(cast iron
up to
200mm
seat bore)
250
up to
200mm
seat bore
250
seat bore
250mm
and larger 300
Length
L
mm 600 600 730 730 730 850
H4 mm 390 390 390 451 451 652