Samson 3271 - Disposal; Disposal Regulations and Procedures

15 Annex
15.1 Tightening torques, lubri-
cants and tools
uAB0100 for tools, tightening torques and
lubricants
15.2 Spare parts
1 Top diaphragm case
2 Bottom diaphragm case
4 Diaphragm
5 Diaphragm plate
6 Hose clamp
7 Actuator stem
8 Ring nut
9 Hex nut
10 Spring
11 Spring
12 Spring
15 Collar nut
16 Vent plug
19 Compressor on the hose clamp (6)
20 Hex bolt
21 Hex nut
22 Hex bolt (preloading)
23 Hex nut (preloading)
24 Screw plug
25 Shim
26/27 Stem connector clamp
28 Clamp with bracket
29 Hex bolt
30 Hex nut
32 Hanger
40 Radial shaft seal
41 Wiper ring
42 Dry bearing
43 Hex screw for hanger (32)
49 Wiper ring
1)
50 Top actuator stem
51 Stem connector
52 Screwed ange
54 Ring
55 Pointer
56 Hex nut
1)
57 Coupling nut
58 Washer
59 Yoke
60 Handwheel
61 Dowel pin
62 Dowel pin
63 Threaded pin
64 Cap screw
65 Hex bolt
66 Lock nut
67 Snap ring
68 Axial needle seal
69 Washer
70 Adjustment nut
73 Cover
74 Lock nut
75 Top diaphragm case
76 Radial shaft seal
77 Dry bearing
100 Nameplate
101 Label (preloading)
106 Grooved pin
1)
Only for version with 240cm² actuator area
2)
Replaces collar nut (15) in version with travel
stop or handwheel