4-4 EB 8048-2 EN
Shipment and on-site transport
slings against slipping by using a con-
nector.
2. Carefully lift the control valve. Check
whether the lifting equipment and acces-
sories can bear the weight.
3. Move the control valve at an even pace
to the site of installation.
4. Install the valve into the pipeline (see the
'Installation' section).
5. After installation into the pipeline: de-
pending on the type of connection (e.g.
welding joint, anged joint etc.) check
whether the valve in the pipeline holds.
6. Remove slings.
To Next Page
Loading...
Need help?
General
