Samson 42-36 E - Page 14

1-10 EB 3018 EN
Safety instructions and measures
NOTICE
!
Risk of damage to the electric actuator due to incorrect operation of the manual over-
ride.
The actuator stem of the electric actuator can be adjusted manually.
Î Do not operate the manual override while the actuator is in operation. Only operate
the manual override of actuators without fail-safe action in the de-energized state.
Risk of damage to the electric actuator by moving the actuator stem too far.
The actuator stem of the electric actuator can be adjusted manually.
Î Only retract the actuator stem as far as the end position at the maximum.
Risk of damage to the electric actuator due to incorrect connection of the voltage.
The electric actuator has terminals to retract the stem (eL terminal) and to extend the
stem (aL terminal).
Î Do not apply a voltage to eL and aL at the same time.
Malfunction due to a conguration that does not meet the requirements of the appli-
cation.
The electric actuator is congured for the specic application by setting conguration
items and parameters.
Î Perform the conguration for the specic application during start-up and after a re-
set to default settings.
SAMSON's After-sales Service can support you concerning lubricant, tightening torques
and tools approved by SAMSON.
Note