Samson 611 - 9 Decommissioning and Removal; Removing the I;P Converters; Disposal; 10 Annex

EB 6116 EN 41
Decommissioning and removal
9 Decommissioning and
removal
Risk of fatal injury due to the ignition of an
explosive atmosphere.
Incorrect installation, operation or
maintenance of the i/p converter in
potentially explosive atmospheres may lead
to ignition of the atmosphere and cause
death.
Î The following regulations apply to instal-
lation in hazardous areas: EN60079-14
(VDE0165, Part1).
Î Installation, operation or maintenance of
the i/p converter must only performed by
personnel who has undergone special
training or instructions or who is
authorized to work on explosion-
protected devices in hazardous areas.
9.1 Removing the i/p con-
verters
1. Disconnect the supply voltage and supply
pressure.
2. Remove the pneumatic and electrical
connections.
3. Remove the i/p converter from the wall,
pipe or control valve (depending on how
it is mounted).
9.2 Disposal
Î Observe local, national and internation-
al refuse regulations.
10 Annex
10.1 After-sales service
Contact SAMSON's After-sales Service for
support when malfunctions or defects arise.
E-mail contact
Youcanreachourafter-salesserviceat
aftersalesservice@samsongroup.com.
Addresses of SAMSONAG and its subsid-
iaries
The addresses of SAMSON, its subsidiaries,
representatives and service facilities
worldwide can be found on our website
(uwww.samsongroup.com)orinall
SAMSON product catalogs.
Required specications
Please submit the following details:
− Order number and position number in
the order
− TypedesignationandcongurationID
− Serial number
− Input and output ranges
− Installation drawing showing the exact
location of the i/p converter
10.2 Certicates
ThetypeexaminationcerticatesandEU
declarations of conformity are included on
the next pages.
DANGER
!