Samson 611 - 4 Measures for Preparation; Unpacking; Transporting and Lifting; Storage

EB 6116 EN 25
Measures for preparation
4 Measures for preparation
After receiving the shipment, proceed as fol-
lows:
1. Check the scope of delivery. Compare
the shipment received with the delivery
note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).
4.1 Unpacking
Î Do not remove the packaging until im-
mediately before installation.
Î Dispose of the packaging in accordance
with the valid regulations.
4.2 Transporting and lifting
Transport instructions
− Protectthedeviceagainstexternalinu-
ences (e.g. impact).
− Protect the device against moisture and
dirt.
− Observe the permissible ambient tem-
peratures(seesection3.2).
4.3 Storage
Risk of device damage due to improper
storage.
Î Observe the storage instructions.
Î Contact SAMSON in case of different
storage conditions.
Storage instructions
− Protectthedeviceagainstexternalinu-
ences (e.g. impact).
− Protect the device against moisture and
dirt. Store it at a relative humidity of less
than75%.Indampspaces,preventcon-
densation. If necessary, use a drying
agent or heating.
− Make sure that the ambient air is free of
acids or other corrosive media.
− Observe the permissible ambient tem-
peratures(seesection3.2).
− Do not place any objects on the device.
4.4 Preparation for installation
Î Check the device for damage.
Î Check the connections to make sure they
are clean.
NOTICE
!