Samson TROVIS 5573 - 8 Setup; 8.1 Selecting the operating mode

EB 5573 EN 8-1
Setup
8 Setup
8.1 Selecting the operating mode
Day mode (rated operation): regardless of the programmed times-of-use and summer mode,
the set points relevant for rated operation are used by the controller. Icon:
Night mode (reduced operation): Regardless of the programmed times-of-use, the set points
relevant for reduced operation are used by the controller. Icon:
Control operation deactivated: regardless of the programmed times-of-use, control opera-
tion remains deactivated. The frost protection is activated, if need be. Icon:
Automatic mode: during the programmed times-of-use, the controller works in day mode
(rated operation). Outside these times-of-use, the controller is in night mode (reduced opera-
tion), provided control operation has not been deactivated due to the outdoor temperature.
The controller switches automatically between both operating modes. Icon:
Manual mode:valvesandpumpscanbecontrolledmanually(seeChapter8.6).Icon:
9. Turn the rotary switch to (operating modes). See the 'Operation' chapter.
blinks.
Insystemswithonlyonecontrolcircuit(e.g.systemAnl1.0),steps2and3(toselectthe
control circuit) are not required.
10. Select the control circuit for which the operating mode is to be set [q]:
1: Heating circuit 1
2: Heating circuit 2
3:DHWheating/circulationpump
Only those control circuits are available for selection which can be controlled by the se-
lected system.
11. Conrmtheselectedcontrolcircuit[Û].
12. Select operating mode [q]:
, , or .
13. Conrmtheselectedoperatingmode[Û].
14. Turn the rotary switch back to normal switch position
(information level).
In automatic operation, the current phase of the time program (
for day mode or for
night mode) is displayed in the information level together with the
icon.
Note