Samson UHF Micro 32 User Manual

16
Setting Up and Using the
Micro 32 System
10. If you hear distortion at the desired volume level, first check to see whether the red
“Peak” LED on the M32 is lighting. If it is not, make sure that the gain structure of your
audio system is correctly set (consult the owners manual of your mixer and/or amplifier for
details). If the red “Peak” LED
does light, do the following:
• If you are using an H32 transmitter, use the supplied plastic screwdriver to turn its AF
Level control (trimpot) slowly counterclockwise (towards the “Min” position) until the
distortion disappears.
• If you are using a T32 transmitter with connected lavalier microphone or headset, its
AF Level control has been factory preset to provide optimum level for the particular
lavalier or headset model being used and so no adjustment should be necessary. Any
distortion present should therefore simply be a matter of the microphone being too
close to the mouth; try moving it further away. If this does not solve the problem, use
the supplied plastic screwdriver to turn the AF Level control (trimpot) on the T32 slowly
counterclockwise until the distortion disappears. If you are using a T32 transmitter
with an instrument such as electric guitar or bass, lower the output level of the
instrument until the distortion disappears. Alternatively, you can use the supplied
plastic screwdriver to turn the AF Level control (trimpot) on the T32 slowly
counterclockwise until the distortion disappears.
11. Conversely, if you hear a weak, noisy signal at the desired volume level, again make
sure that the gain structure of your audio system is correctly set (consult the owners
manual of your mixer and/or amplifier for details). If it is and the signal coming from the
M32 is still weak and/or noisy, do the following:
• If you are using an H32 transmitter, use the supplied plastic screwdriver to turn the AF
Level control (trimpot) on the transmitter slowly clockwise (towards the “Max” position)
until the signal reaches an acceptable level.
• If you are using a T32 transmitter with connected lavalier microphone or headset, its
Level control has been factory preset to provide optimum level for the particular
lavalier or headset model being used and so no adjustment should be necessary.
Any weakness of signal should therefore simply be a matter of the microphone being
too far from the mouth; try moving it closer. If this does not solve the problem, use the
supplied plastic screwdriver to turn the AF Level control (trimpot) on the T32 slowly
clockwise until the signal reaches an acceptable level. If you are using a T32
transmitter with an instrument such as electric guitar or bass, raise the output level of
the instrument until a good signal is achieved. Alternatively, you can use the supplied
plastic screwdriver to turn the AF Level control (trimpot) on the T32 slowly clockwise
until the signal reaches an acceptable level.
12. If you want to use headphones to monitor the transmission, connect a standard
“Walkman”-type 30 ohm headphone to the M32 headphone output and adjust the Level
control until the desired level is reached.
13. When first setting up the Micro 32 system in a new environment, it’s always a good
idea to do a walkaround in order to make sure that coverage is provided for your entire
performance area. Accordingly, turn on both the transmitter and M32 receiver. If you are
using a video camera, use the supplied velcro strip to attach the M32 to the side of the

Samson UHF Micro 32 Specifications

General

Brand	Samson
Model	UHF Micro 32
Category	Microphone system
Language	English