Samson UHF series - Page 16

14
6: Battery holder - Insert a standard 9-volt alkaline battery here. As
shown in the illustration below, installation is accomplished as follows:
unscrew the bottom section of the UH-4 (turn counterclockwise), then
pull out the nylon sled (marked “Pull To Open”). Next, place the battery
in the UH4, with the battery terminals facing the top of the mic capsule,
and, finally, push the sled back in. The purpose of the sled is to ensure a
tight fit; if you encounter resistance, you have installed the battery back-
wards—remove it, reverse the position of the terminals, and reinstall.
Guided Tour - UH-4
SAMSON
PULL
TO
OPEN
+
PULL
OUT
PUSH
IN
PUSH
IN