NOTE
" YoumustconnectanAnynet+deviceusinganHDMIcable.SomeHDMIcablesmaynotsupportAnynet+functions.
" Anynet+workswhentheAVdevicesupportingAnynet+isinthestandbyoronstatus.
" Anynet+supportsupto12AVdevicesintotal.Notethatyoucanconnectupto3devicesofthesametype.
" However,youcanconnectonlyoneHomeTheater.
Anynet+ Menu
The Anynet+ menu changes depending on the type and status of the Anynet+ devices connected to the T_,
View IV Changes Anynet+ mode to TV broadcast mode.
Device List Shows the Anynet+ device list.
Recording: (*recorder) Starts recording immediately using the recorder. (This is only available for devices that
support the recording function.)
Stop Recording: (*recorder) Stops recording.
(devicename) MENU Shows the connected device menus. For example, if a DVD recorder is connected, the disc
menu of the DVD recorder will appear.
(devicename) INFO Shows the play menu of the connected device. E,g, If a DVD recorder is connected, the
play menu of the DVD recorder will appear.
Receiver Sound is played through the receiver.
Ifyou have connected more than one recording device, they are displayed as (*recorder) Ifyou have connnected only one
recording device, it is displayed as (*devicename).
Setting Up Anynet+
(_ MENU ITTI--_Application _ Anynet+ (HDMm-CEC) --_ ENTER[_
Ill Setup
Anynet+ (HDMm-CEC) (Off / On): To use the Anynet+ Function, Anynet+ (HDMm-CEC) must be set to On.
When the Anynet+ (HDMm-CEC) function is disabled, all the Anynet+ related operations are deactivated.
Auto Turn Off (No / Yes): Set an Anynet+ Device to turn off automatically when the TV is turned off.
IfAuto Turn Off is set to Yes, running external devices will turn off at the same time as the TV powers off.
However, a device may not turn off if recording is in progress.
May not be enabled depending on the device.
English 27
To Next Page